Quadcopter Update

Well, I’ve learnt the difference between ‘Acro’ mode and ‘Self Level’, and it only cost me one propeller.

This afternoon after work, the kids and I took the quadcopter to the local oval. It started out as a lot of fun, but I hadn’t realised that you can change the mode by stick input on the controller. Somehow I managed to knock it from Self Level mode (I need all the help I can get at the moment – I’m up to almost 6 minutes of flight time), into ‘Acro’ mode. I’m assuming ‘Acro’ is an abbreviation for Acrobatic, because it got very exciting after that. If you are expecting the quad to self level when you center the sticks, it takes a moment to realise that it isn’t happening. You don’t have a lot of moments available.

Here is how the construction has progressed. I’ve completed a bunch, and learnt that I have more to go. It’s flyable now (or it was before this afternoon’s adventure), but there is lots of room for improvement.

Successes:

Failures:

  • Install video cam
  • Install video TX

i’m not 100% sure what has gone wrong here. I wired the camera and the TX together using the supplied wiring harness and powered it up. The video TX blew and managed to ignite the heatshrink. I suspect its taken out the camera too. My best guesses are faulty wiring or faulty board. Without better diagnostic equipment, there isn’t much I can do about it. I’ll have to order replacements when funds allow.

To do:

  • Replace the rear props with some red ones. Its hard to maintain orientation with the yellow front and white rear. There isnt enough contrast. Also, I broke the white one. 🙂
  • Re-mount the KK2 and re-level it. It tore off two of four pieces of mounting tape in the impact.
  • ESC Calibration (electronic speed controllers)
  • Instal SimonK firmware on ESCs, I’m leaving this until I have a rainy day
  • build (anti)vibration isolation platform

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s